That way, the bridge will not fall out of the rack, but can be removed by lowering it until the stick fits through the gap. The notch needs to be slightly wider than the narrowest part of the stick. Cut a notch with your jigsaw in the front of the top shelf to one of the holes.Do not rout the back edge of either shelf.Īdding a routed edge provides a big payoff to the look of the cue rack You want to rout the edges that will be visible: the bottom side of the top shelf and the top side of the bottom shelf. With an ogee bit, rout a decorative edge on both shelves.You can wrap tape on the bit to mark the depth. ![]() Make the depression just deep enough for the furniture pads. Note that you can’t use a hole saw for this! Use the same bit on the bottom shelf to make a depression about ¼” (5 mm) deep. Use a 1½” (38 mm) spade bit to drill holes through the top shelf.The holes are closer to the front, leaving space behind the cues for your ball rack, brush and chalk. Space the holes 2½” (63 mm) apart, and 1½” (38 mm) from the front edge. Choose which board will be the top shelf and which will be the bottom - you’ll be looking at the underside of the top shelf, and the topside of the bottom shelf - and mark the center points of the cue holes.Use a narrow fine-toothed jigsaw blade for best results cutting a tight curve like this *I used scrap redwood header cap moulding with a 2¼” x 1½” (5.7cm x 3.8 cm) ogee profile. Try your local lumber yard or recycled building materials store - you only need 28″ of material, so you’re likely to find it in a leftovers bin. I happened to have the cap moulding laying around, but you may not be able to find it at your local big box hardware store. This rack comes in three different colors, oak, mahogany, and black. Their six-cue wall-mounted rack is a simple way to keep your sticks and accessories put up and out of the way when you aren’t using them. ![]() If you choose nice wood for the project, you’ll have an elegant-looking piece of furniture for your billiards room. The Games & Sports Expert brand is another popular maker of pool and billiards tools. This pool cue rack is easy and cheap to build, plus it’s simple to install with standard plastic drywall anchors. The red mahogany stain on the rack fits in perfectly with our purple pool table Fortunately, the old scrap pile was just a few steps away, and about an hour and a half later, we had the stain drying on this beauty. We had made sure to get everything we needed to shoot pool, right down to the chalk, but danged if we hadn’t thought about where we’d put the cues. This article may contain affiliate links, which help to support this site, at no cost to you.Ībout 15 seconds after we got our pool table set up, we both looked around the room and realized something was missing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |